Make your fireplace more efficient with The Original Grate Heater formerly known as Cozy Grate Heater by Heat-N-Glo. More than 40,000 BTU's of heat per hour can be produced with this heavy-duty fireplace grate heater. Easy to install, simply replace your old fireplace grate with The Original Grate Heater, plug in the 9' power cord and build a fire. Within minutes the firebox will reach 110 degrees and begin to blow heat from the thermostatically controlled blower. Once your firebox temperature reaches 90 degrees, the blower turns off automatically. In the case of a power outage you will need to remove the unit from your fireplace before lighting a fire.
The versatile unit can be used with or without a glass door. If used with a glass door, the door sits on top of the bar and would be elevated 1 3/8" high. The log basket measures 11" high at the front and 8" high in the rear, and measures 7 1/2" deep. Designed for masonry fireplaces, not intended for zero-clearance fireplaces.
This grate heater may be used with a gas log lighter as long as clearances allow for placement under the grate.
- 40,000+ BTU's of Heat Per Hour
- 100 CFM Blower (variable speed)
- Rheostat and Thermostat Controlled
- Heavy 12 Gauge Steel Tubing Guaranteed 3 Years
- Turns On Automatically at 110 Degrees and Off at 90 Degrees
- All Electrical Components U.L. Approved & 1 Year Warranty
- The Motor is Encased and Insulated to Keep it Protected From Heat
Note: The Original Grate Heater should run on low for 10-15 minutes, on initial start up. This will add longevity to the life of the motor.
Note: Pictured with optional Brass Trim Bar. All units have a 29 1/4" wide x 2" deep front rail and include black extenders that provide a maximum front rail width of 51 1/4". Your glass door (if applicable) sits on top of the front rail and is elevated 1 3/8".