Product Note: Used once and returned. Original packaging slightly beat up. Tested in excellent working condition. Only 1 available.
Less Than Perfect Items are sold AS-IS and CANNOT be returned.
Coupons or special promotions not available on this item.
Make your fireplace more efficient with a Cozy Grate Heater by Heat-N-Glo. More than 40,000 BTU's of heat per hour can be produced with this heavy-duty fireplace grate heater. Easy to install, simply replace your old fireplace grate with the Cozy Grate Heater, plug in the 9' power cord and build a fire. Within minutes the firebox will reach 110 degrees and begin to blow heat from the thermostatically controlled blower. Once your firebox temperature reaches 90 degrees, the blower turns off automatically.
The versatile unit can be used with or without a glass door. If used with a glass door, the door sits on top of the bar and would be elevated 1 3/8" high. The grate measures 8" high while the log basket measures 7 1/2" deep. Designed for masonry fireplaces, not intended for zero-clearance fireplaces.
Note: The Cozy Grate heater should run on high for 10-15 minutes, on initial start up. This will add longevity to the life of the motor.
Features:
40,000+ BTU's of Heat Per Hour
100 CFM Blower (variable speed)
Rheostat and Thermostat Controlled
Heavy 12 Gauge Steel Tubing Guaranteed 3 Years
Turns On Automatically at 110 Degrees and Off at 90 Degrees
All Electrical Components U.L. Approved & 1 Year Warranty
The Motor is Encased and Insulated to Keep it Protected From Heat
Note: Pictured with optional Brass Trim Bar. All units have a 29 1/4" wide x 2" deep front rail and include black extenders that provide a maximum front rail width of 51 1/4". Your glass door (if applicable) sits on top of the front rail and is elevated 1 3/8".
Fits a Masonry Fireplace Opening: 29 1/4" Wide to 51 1/4" Wide and 20" Deep
Heavy 12 Gauge Steel Tubing Guaranteed 3 Years
All Electrical Components U.L. Approved & 1 Year Warranty
Item Weight: 55.00 LB
Model: TR-20LH-LTP
Oiling a Cozy Grate Heater
On the side of the blower box, bend back the heat shield so you can access the two screws on the back. There is also one screw on the front side of the cover. ALL must come out. Inside, there are two nuts, these hold the motor to the motor housing. Remove the nuts. The fan blades will also come out with the motor so you can clean them as well. There will be two little oil holes, one on each end of the motor.You can use any type of light machine oil or 3-in-1.
All Electrical Components U.L. Approved & 1 Year Warranty
Steel Tubing has a 3 Year Warranty
Questions? Call Toll-free 866-667-8454 All Orders Processed on Secure Servers
Hours: 9AM to 7PM Mon-Fri - Saturdays 9AM to 4PM Eastern Time Zone
Call Toll Free 866-NORTHLINE (866-667-8454)
Outside US call 989-821-7040
Fax 989-821-7203
All Orders Processed on Secure Servers
