4" Selkirk VP Pellet Vent Pipe Tall Cone Flashing - 4VP-TF

Selkirk Tall Cone Roof Flashing is used to weather proof the penetration of vent pipe through the roof. When installing the Tall Cone Roof Flashing, a storm collar is required. When choosing the proper flashing, base your decision on the pitch of the roof. The Tall Cone Roof Flashing is made of galvalume and is for use on flat roofs, chase enclosures or masonry chimneys.

VP Pellet Pipe is used for venting pellet or corn burning stoves approved for use with PL-Vent. The appliance's flue gases must not exceed 570° F (298.80° C).

See all 4" VP Pellet Pipe Components

Additional Information:

Metalbestos gives you the safe, efficient, and cost-effective venting system that's engineered precisely for pellet and corn burning stoves. Model VP Pellet Pipe has been tested and listed by Underwriters' Laboratories, Inc., in accordance with UL-641 Standard for Low Temperature Venting Systems, as well as the applicable requirements from UL-103 Standard for Residential Type and Building Heating Appliance Chimneys. Model VP Pellet Pipe, when installed according to Metalbestos installation instructions, complies with National Safety Standards, such as NFPA-211. The system is rated for flue temperatures up to 570° F.

  Installation Instructions

Specifications:

• Diameter: 4"
• Construction Materials: 304 Stainless Steel Inner Wall, Paintable Galvanized Outer Wall
• Clearance: 3" to Combustible Material
• Listings: UL 103, ULC S609, ULC/ORD C441 and UL 641

  Manufacturers Limited Lifetime Warranty